Call (480) 279-2456

2006 Hummer H2

//2006 Hummer H2

2006 Hummer H2

Hummer H2

Mileage
160,026
Service Date
6/11/2020
Services Performed
  • Add cleaner to transmission. Test drive to verify operation and circulate cleaner. Use fluid exhange machine to remove old fluid and add new. Add fluid conditioner and verify proper level. Test drive to verify proper operation.
  • BG On The Road Service Card
  • Inspect all hydraulic lines and hoses. Inspect calipers and wheel cylinders if applicable. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean. Test drove to verify proper brake operation.
  • Inspect hoses and clamps. Add cleaner to coolant and run through engine, radiator, and heater core. Installed coolant flush machine in-line to coolant system. Pulled vacuum on system to remove old coolant. Pushed 3 gallons of new coolant through cooling system. Add conditioner and sealant to system. Check thermostat and electric cooling fan operation. Test drive and verify proper operation of cooling system.
  • Remove drain plug and drain fluid. Clean threads, put thread sealant on drain plug and installed. Removed fill plug and cleaned threads. Filled with new fluid and verify correct level. Installed plug.
  • Remove fill plug and clean threads. Extract old fluid. Fill with fresh fluid and verify correct fluid level. Re-install plug.
  • Removed air intake boot to access throttle body. Attached BG intake cleaning tool to clean throttle body and decarbon intake system. Perform throttle relearn as needed. Disconnected fuel lines and installed BG injector cleaning tool. Started vehicle and ran off BG injector cleaner. Removed tool and reconnected fuel lines. Added BG 44k to fuel tank. Cleared engine codes set during service. Test drove to verify proper operation.
  • Removed axles from vehicle to gain access to seal. removed old axle seals and replaced with new. Replaced left side axle hub while it was out due to damage of spline and c clip found.
  • Removed differential fluid using BG differential service tool. Filled rear differential with BG synthetic fluid. Verified fluid at proper level. Road tested vehicle for proper operation.
  • Removed oil pan from vehicle and replaced gaskets. Re installed oil pan and torqued all bolts to spec.
  • Removed old exhaust manifold and replaced gasket. Re installed manifold and torqued all bolts to spec.
  • Removed old leaking steering gear and replaced with new. Transferred pitman arm while gear was out and torqued all bolts to spec.
  • Removed transmission from vehicle and flywheel to gain access to rear main seal. Removed rear main seal/plate and replaced with new. Re installed all parts that were removed and torqued all bolts to spec.
  • Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and tire condition. Check ride height. Check alignment of all four wheels. Adjust caster, camber, toe-in, and thrust angle as needed on all four wheels. Center steering wheel and adjust steering angle as needed. Road test when complete. Includes 1 re-check with toe adjust if needed within 12 months
  • Test drove vehicle. Raised on lift and performed vehicle inspection. Filled out vehicle condition report and submitted to service advisor.
  • Was able to verify customer concern, found code po430 cat below threshold. Vehicle has bad exhaust leak on same side tech would like to fix exhaust leak first and clear light.
 
Bill M. gave our service a 5 star review on 6/13/2020
2020-06-14T22:01:28+00:00